- Inner diameter before contraction: about 27 mm- Inner diameter after shrinkage: approx. 18 mm- shrinkage ratio: approximately 2:1- Wall thickness: approximately 0.13 mm- Color: red- Before shrinkage, the tubes are soft and moving- After shrinkage, the tube is stiff / hard- Shrinkage: With a hot air blower.Price one meter.
- Inner diameter before contraction: about 29 mm- Inner diameter after shrinkage: approx. 14 mm- shrinkage ratio: approximately 2: 1- Wall thickness: approximately 0.10 mm- Color: not color (transparent)- Before shrinkage, the tubes are soft and moving- After shrinkage, the tube is stiff / hard- Shrinkage: With a hot air blower.Price one meter.
- Inner diameter before contraction: about 25 mm- Inner diameter after shrinkage: approx. 16 mm- shrinkage ratio: approximately 2:1- Wall thickness: approximately 0.13 mm- Color: red- Before shrinkage, the tubes are soft and moving- After shrinkage, the tube is stiff / hard- Shrinkage: With a hot air blower.Price one meter.
A ring nozzle is used to connect the cable to the electrical installation elements. The terminal is mounted on the cable by pushing it over the open part of the cable and pressing with a press or pliers. Fastened with a screw of the appropriate diameter. This will reduce the overheating of the conductors and the insulation of the cables by soldering the...
Connector set EST PANEL 80A / 120A plug + socket with panel
Connection to the connection panel - high-current connection with the mounting and cable shield. EST 80 / 120A For heavy loads.
The socket is well attached and stable in a variety of harsh working conditions. The advantage of the joint is that it provides good insulation and protection...
Optional accessories for the HTC charger series (HTC 1000/2000/4000)
The accessories can be connected to the compatible charger using the connector system.
The HTC charging plug for on-board power sockets is intended for quick, easy and safe connection of the battery via the on-board power socket.
Please observe the warning and safety instructions for...
For holding 18650 battery cells.
There is an improvement with PVC insulation. + and - to have one electrical contact. For sides it would only hold, but not shorten, through the battery housing. The colors are different. It will be more convenient to separate the polarities during installation.
Price for two terminals. One pair.
Plug with wires JST SMP-02V-BC
JST two-pin plug with 2 wires
model: SMP-02V-BC
wire type: S-AWG22 / 15 red / blk (2PIN)
cable length [mm]: 150
wire color: red and black
conductor cross-section: 0.326 mm2
price is for one connection.
EN 
LT
