My products cart
There are no more items in your cart
Battery packs equipment
PVC tube 90 mm (for D/R20)
PVC90
- Inner diameter before contraction: about 90 mm- Inner diameter after shrinkage: approx. 45 mm- shrinkage ratio: approximately 2: 1- Wall thickness: approximately 0.1 mm- Color: transparent- Before shrinkage, the tubes are soft and moving- After shrinkage, the tube is stiff / hard- Shrinkage: With a hot air blower.Price one meter.
In warehouse
€0.70
Rayovac battery holder - box
999782
Users of hearing aids and cochlear implants must have spare batteries that they can use while studying or working.
These specially designed battery holders can hold up to three hearing aid or cochlear implant batteries. Just add the batteries and attach them to the key fob. This will be a backup.
Number of batteries: 3 pcs
Capacity: 675, 312, 13 and 10...
In warehouse
€0.97
PCM/BMS LiFe for 10S cell 100Ah
PCM8S/100A
Life BMS protection with balancing.
Nominal voltage: 33.00V
Minimum voltage: 25.00V
Maximum voltage: 36.00V
Charge current: 30Ah
Discharge current: 100Ah
With cell balancing. Has two thermal controls. With balancing connector.
Dimensions: 74mm x 105mm x 8mm
In warehouse
€39.97
PCM/BMS Li-ion for 6S cell 30Ah
PCM6S/30A
Protection Circuit Board for 6S Li-ion/Li-polymer battery pack
6S cell PCM/BMS
Datasheet 30Ah to the photo.
Minimum voltage: 15V
Maximum voltage: 25.2V
In warehouse
€8.49
PCM/BMS for 10S lithium cells 20Ah
PCM10S/20A
Overload, short circuit protection.Discharge Current: 20AMaximum peak current: 35ACharging voltage: 42VMaximum charging current: 5AMaximum voltage per cell: 4.28 ± 0.05 VMinimum voltage on the cell: 2.55 ± 0.08 VNominal discharge on the cell: 2.9 ± 0.1 VOperating voltage: 150mVStandby discharge: ≤10uASize: 72mm x 44mm x 10mm
Connection:Connect the charge...
In warehouse
€12.96
Contacts JST XH 3 pin
JSTXHP-3
Manufacturer: JSTType XHOften used in lithium packages. 4 checkpoints.Cable length is about 20cm
In warehouse
€2.00
€2.19
PCM for 1 Li-ion cell 6Ah
VXZ001
In the table rated is voltages: 3,6V
Charge/discharge current - 6AhMinimum voltage: 2,5VMaximum Voltage: 4,2V
Dimensions: 19x4x2.5mm
The length of the welding tape is 30mm and 40mm
Total length: 95mm
In warehouse
€0.58
PCM for "power bank" USB-C/3
LIPCB7V3
POWER BANK. Mounting plate + indication.
Input: 5V / 3A USB -C: 5V3A 9V / 2A 12V / 1.5A
Output: USB -A: 5V / 3A USB-C: 5V / 3A 9V / 2A 12V / 1.5A + Apple connector
Power: 18 W, if the device is more than 18 W, can not be used can even burn.
Supports: QC3.0 QC2.0: FCP: PE2.0 PE1.1: SFCP
Input / output overvoltage / overcurrent / short circuit protection....
In warehouse
€4.99
Power supply DC-DC from 5V to 30V
VH010445
"Step Down Buck" has a constant voltage and constant current function (CC CV).This converter is manufactured with XL4015E1Operating temperature: -40 - 85 CelsiusSupply voltage: 5V-32VOutput voltage: 0.8 - 30VCurrent: 5AConversion efficiency: 95%Switching frequency: 300 KHzOutput ripple: 50mVOutput power: 30WSize: 51x26.3x14mm
In warehouse
€3.59
Voltage converter DC-DC from 8V to 35V to USB
VHX13028
Voltage converter DC/DC to 5V USBStep Down Buck DC/DC Converter. Power supply module 2 USB channels at the output. From 8V to 35V2 channels of USB connector support current output, total output current up to 8A.Uses input protection to increase conversion efficiency and reduce losses.Output with surge protection.8-35V extremely wide input voltage, in the...
In warehouse
€7.14
Power supply DC-DC from 2,7V to 24V 30W
VHX0016A
Voltage converter to 24 Volts
DC voltage converter. Input from 2.7V to 5.5V (this is the voltage of one or two batteries) can increase from 3.5V to 24V. Voltage, using devices, is set with the help of a potentiometer. The load cannot exceed 30W.
In warehouse
€5.98
PCM/BMS/Charger for 1S Lithium 3,6V 2Ah
V012794
4 in 1 charging / discharging / lithium battery protection / battery level indicator.
Charging voltage: DC 4.5-5.5V (DC 5V recommended)
Charging current: 0-2.1A
Charging quiescent current: 100uA
Full Voltage: 4.2V+-1%
Discharge current: 0-2.4A
Discharge quiescent current: 50uA
Output voltage: 5V
Output current: 0-2.4A;
Dimensions: 25 x 16 x 4 mm
The...
In warehouse
€1.55
PCM for "power bank" USB-C
VX52136
POWER BANK. Mounting plate + indication.
USB - C open board 5V with protection 1Ah
Voltage: 4.35-6V (recommended voltage 5V)
Charge cut-off voltage: 4.2V +/- 1%
Maximum charging current: 1000 ma
Battery overcharge protection voltage: 4.28V
Battery Recharge Boost Voltage: 4.00V
Battery discharge protection voltage: 3.0V
Battery end of discharge voltage:...
In warehouse
€1.09
Connector BC10 with wire
BC10
Six-point connector for charging the battery pack. With 10cm cord.
In warehouse
€3.80
PCM for "power bank" USB-C
LIPCB7V2
POWER BANK. Mounting plate + indication.
Input: 5V / 3A USB -C: 5V3A 9V / 2A 12V / 1.5A
Output: USB -A: 5V / 3A USB-C: 5V / 3A 9V / 2A 12V / 1.5A + Apple connector
Power: 18 W, if the device is more than 18 W, can not be used can even burn.
Supports: QC3.0 QC2.0: FCP: PE2.0 PE1.1: SFCP
Input / output overvoltage / overcurrent / short circuit protection....
In warehouse
€8.60
Mascot DC Connectors
jjjjjjj
Connectors of different sizes. Please look to the manufacturer's data file ( Specification) and provide the code for the required connector. Price per unit.
In warehouse
€2.00
Battery box for AA /CR123
DAA/123
Battery box for Two psc AA battery. Or 3 psc CR123 type battery. White color.
Price for one box.
Outer dimensions: 60 mm x 45.5 mm x 21.5 mmInner dimensions: 56.4 mm x 41.5 mm x 19.50 mmMaximum battery length 14500: 56.00 mmMaximum battery length 16340: 38.50 mm
In warehouse
€0.18
18V for Makita one set
PCMMAKITAZ
Full set for Makita 18V
Lithium battery control circuit board Protection chip for electric tools battery, welding tape, screws, plastic holders.
Compatible with: For Makita only
Its main function to battery are: over charge protection, over discharge protection, short circuit protection, over current protection, reverse charge protection, over heat...
In warehouse
€13.49
PCM for 1S Li-ion cell 12Ah
PCM1S/12A
In the table rated is voltages: 3,6V
Charge/discharge current - 12AhMinimum voltage: 2,5VMaximum Voltage: 4,2V
Dimension: 48x9x2,5mm
Total 90mm
In warehouse
€0.64
PCM for 1 Li-ion 18650 2,5Ah (round)
PCM1S2A
In the table rated is voltages: 3,6VMinimum voltage: 2,5VMaximum Voltage: 4,2V
With plasticis box.
In warehouse
€0.99
18V Li-ion Battery PCM For Makita (big)
PCMMAKITAS
Voltage: 18V
Max. Charging current: ≤12A
Overload voltage protection: 4.25v
Overcharge detection time: 2s
Overheat protection: 100 ℃
Restoration of overheating protection: 85 ℃
Compatible with: For Makita onlyIts main function to battery are: over charge protection, over discharge protection, short circuit protection, over current protection, reverse...
In warehouse
€17.98